,
€
*
Instead of
€
1381_des
1381_produits_achetes
Eco-participation
including eco-tax :
€
Valid
du
to
While supplies last
Ref. :
AR0052945
Zimo MX600 Ho decoder for locomotives in Dcc format. Mint with manual.
Has 4 functions (including two for front and rear lights), it can be used in DCC and in analog DC (not compatible with mfx/MM and AC analog).
Protection against short circuits and overcurrent (built-in circuit breaker in case of overcurrent).
Built-in temperature sensor: motor shuts off above 100°C, with a light signal sent via the lanterns. Returns to normal when the temperature drops back to 20°C.
- Addressing from 1 to 10239
- Switchable automatic analog detection mode
- 14/28/128 speed steps
- Speed curve in 3 or 28 points (applicable to analog)
- Can operate in km/h or mph
- Adjustable back EMF with load compensation setting
- Motor regulation at 20 or 40kHz, also at low frequency from 30 to 159Hz (for older motors)
- Shunting mode, braking mode, adjustable inertia
- management of multiple units with shared function control
- Lenz ABC, Marklin, and Zimo HLU braking
- extended function mapping
- many lighting effects (SAL, headlight/spotlight mode, adjustable light intensity...)
- smoke generator adjustment for Seuthe type in steam or diesel mode and management of integrated fan smoke generator
- Krois-type automatic coupling management
- SUSI/servo motor interface
The MX600 can provide 0.8 amp current (peak allowed 1.5). It has 4 functions (all wired – including two for front and rear lights), and it works with DCC and analog DC (not compatible with mfx/MM, do not use on AC analog).
Also available in new NEM651 (6-pin), NEM652 (8-pin), or with a Plux12 interface. All Zimo decoders include RailCom functionality.
Maximum voltage: 30 volts.
Decoder dimensions: 25 x 11 x 2mm